Month: September 2023

Great spot for our booth.

Rear demo setup.

I redid the HydroDrop demo rack setup that sits on the slider bed. This is a specific setup used for the street and park shows.

This setup is super fast and efficient setting up. In the past I would literally wire solenoids up, one by one.

We did a few things differently from the past. That means we are learning the trade. There is always room for improvement.

This essentially the same outdoor setup we’ve always used, only a lot cleaner.

We woke up heck of early this morning and headed to Woodland CA. for the annual show. The weather forecast was light rain during the morning hours. We did get a few heavy rain downpours on the way but that’s part of the adventure.

The expected truck count actually registered hit 1000. The spectators were able to enjoy the entire venue minus the VIP lounge for free.

We got detoured into taking another way into Main Street using the West side entrance. We ended up getting a primo spot after I spoke to the staff directing traffic.

I worked on the shop truck demo rack, the goal is to have the demonstration rack up and running with minimal setup time.

Utilizing a couple key pieces as the base configuration. The Bed Slider allows easy access to the booth components and supplies. The Varidesk piece is a new addition the allows the dash display to sit on a pedestal that can be set 11 different heights. This is important when I drop the truck down and the display becomes too low to use properly.